Advertisement
1-3. Replacing CCD Unit
n
It is recommendable to perform procedures 7 and 8 in a clean room.
7. Disconnect the connector from the driver board. Remove the two screws (K3 x 6) to remove the filter
disk unit. Remove the two screws (B2.6 x 4) to remove the driver board.
K3 x 6
8. Install the filter disk unit to the HKC-7081 with the two screws which were removed in procedure 4.
Connect the connector from the filter disk unit to the driver board.
m
. Be very careful not to touch the surface of the filter disk unit when installing the HKC-7081.
. Be sure to remove the dust protection tape from the HKC-7081 previously.
9. Install the HKC-7081 to the front panel with the four bolts.
Fixture:
Allen wrench (width across flat = 2.5 mm)
Tightening torque: 110 x 10
10. Install the ND and the CC filter knobs referring to Section 1-3-4 "Positioning Adjustment for Filter
Knob."
11. Install the HKC-7081 in the reverse order of removal.
1-4 (E)
Filter disk unit
_2
N.m (11 kgf.cm)
Driver board
B2.6 x 4
HKC-7081
Advertisement
