Control Panel Setup - Chamberlain Contractor Series Manual

Operation

Control Panel Setup

LOCK
Your remote controls will NOT work when
LOCK mode is active however your keyless
entry will still allow access to your garage.
Activate:
Press and hold the LOCK button for 2
seconds. The command LED will flash as
long as the lock feature is activated and
your handheld remote control will not
operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2
seconds. The command LED will stop
flashing and normal operation will resume.
LIGHT
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time
interval is indicated by the number of flashes.
Number of times garage door
opener lights flash
1
2
3
4
To cycle through the time intervals repeat the step above.
* Approximately 10 seconds
Command LED
LOCK Button
Time the garage door opener light stays on
1-1/2 Minutes
2-1/2 Minutes
3-1/2 Minutes
4-1/2 Minutes
LIGHT FEATURE (Default is Active)
Deactivate:
Press and hold the LIGHT button until the
garage door opener lights turn on, then off
again.*
Activate:
Start with the garage door opener lights on.
Press and hold the LIGHT button until the
garage door opener lights turn off, then on
again.*
If the command LED is continuously
blinking, the LOCK feature needs to be
deactivated.
MAINTENANCE ALERT SYSTEM (MAS):
Activate/Deactivate:
Press and hold the LEARN button. Then
press the LIGHT button. The service LED
will flash the status; Active is 2 flashes and
deactivated is 3 flashes.
39
Command LED
LOCK Button
LIGHT Button
Service
LED
LEARN
Button
LIGHT
Button