Install The Door Control - 883Lmw - Chamberlain Contractor Series Manual

Install the Door Control

1 Install the Door Control - 883LMW

To prevent possible SERIOUS INJURY or DEATH from electrocution:
Be sure power is NOT connected BEFORE installing door control.
l
Connect door control ONLY to 12 VOLT low voltage wires.
l
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
Install door control within sight of garage door, out of reach of small children
l
at a minimum height of 5 feet (1.5 m) above floors, landings, steps or any
other adjacent walking surface, and away from ALL moving parts of door.
NEVER permit children to operate or play with door control push buttons or
l
remote control transmitters.
Activate door ONLY when it can be seen clearly, is properly adjusted, and
l
there are no obstructions to door travel.
ALWAYS keep garage door in sight until completely closed. NEVER permit
l
anyone to cross path of closing garage door.
INTRODUCTION
®
Compatible with myQ and Security+ 2.0
opener is compatible with up to 2 Smart Control Panels or 4 of any other Security+ 2.0
door controls. NOTE: Older LiftMaster door controls and third party products are not
compatible.
Install door control within sight of garage door, out of reach of small children at a
minimum height of 5 feet (1.5 m) above floors, landings, steps or any other adjacent
walking surface, and away from ALL moving parts of door. For gang box installations it is
not necessary to drill holes or install the drywall anchors. Use the existing holes in the
gang box.
NOTE: Your product may look different than the illustrations.
®
accessories, see page 45. Your garage door
HARDWARE
Screw 6ABx1" (2)
1. Strip 1/4" (6 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back of the door control. The
wires can be connected to either screw.
3. Mount the door control with the hardware provided.
1
1/4" (6 mm)
®
20
2 3