End Panel Layouts - Orion WCC 5001 User Manual

END PANEL LAYOUTS

6002
1
PWR
(R-)
1. PWR (LED blue) - when illuminated indicates that the amplifier is on.
2. HI Input (high level input) - Accepts 1v to 10v input from the headunit's speaker
output. The amplifier will automatically wake-up when the input is greater than
1V.
3. RCA Inputs - accepts RCA input from a source unit, preamplifier, or equalizer.
4. Level Control - continuously adjusts from 150mV to 5V for full power output.
5. Crossover Switch - activates low pass crossover, full (all pass), or high pass
crossover.
6. Low-Pass Frequency Control - adjusts the frequency (50Hz–500Hz) of the low-
pass crossover.
7. High-Pass Frequency Control - adjusts the frequency (50Hz–500Hz) of the high-
pass crossover.
8. Bass - sets the bass boost of the high-pass crossover to 0, 5 or 12dB of boost.
9. PRT (LED red) - illuminates when the PRT (Protection) function is active. Activates
to protect the amplifier when the temperature is too high, the output has a DC
offset, a short was detected on the output, or the amplifier power cables have
been improperly connected (reverse power). If the temperature, DC offset, or
short condition has cleared after approximately 10-seconds the amplifier will
automatically recover.
10. Speaker Connections - accepts two speakers or a bridge connection.
11. 2 ATC Fuses (25 amp) - protects the amplifier from over current situations.
12. Power Connections - accepts up to 8 AWG power and ground cables, and also
has a REM amplifier turn-on terminal (turns on the amplifier when fed +12 V).
4
2 3 4 5
INPUT
X-OVER
HI-INPUT LEVEL
1.5
3 0.8
L
LPF
5V 0.15V FULL
R
10 11
BRIDGED
(R+) (L-) (L+)
FUSE
6 7 8
BASS
LOW PASS HI PASS
PRT
90 90
HPF 0dB 12dB
500Hz 6dB
50Hz 500Hz 50Hz
12
+12V REM GND
FUSE
© 2005 Directed Electronics—all rights reserved
9