Tools Of The Trade; End Panel Layouts - Orion Cobalt CO5001 Owner's Manual

TOOLS OF THE TRADE

Listed next are the majority of the tools required to perform an installation. Having the proper
tools will make the installation that much easier. Some of these tools are necessities; some will
just make the job easier.
● Allen Wrenches (2mm, 3mm & 4mm)
Electric drill with assorted drill bits
●
● Heat shrink tubing
Phillips and flat blade screw drivers
●
● Pliers (standard and needle nose)
RTA (real time analyzer)
●
● Soldering iron and solder
Utility knife
●
● Wire brush or sandpaper for chassis grounding
Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)
●

END PANEL LAYOUTS

Input Plate
Figure 1
Figura 1
Abbildung 1
1. Power LED - When lit indicates that the amplifier is on.
2. High Level Input - Connect speaker output from factory radio to amplifier, will auto
sense signal from radio and turn amplifier on when needed, turn off after 1 minute
without signal.
3. RCA Outputs - provides a full range signal for easy connection to additional ampli-
fiers.
4. RCA Inputs - Accepts RCA input from a source unit, preamplifier, or equalizer.
5. Gain Control - Continuously adjusts from 150mV to 8V input to obtain full power
output.
6. Phase Control Switch - Allows for adjustment of phase and makes bridging ampli-
fiers possible.
7. LPF, FULL, Switch - Selects either Lo-pass crossover or full range crossover.
8. Bass Boost Switch - Adjusts bass gain in three steps (0dB, 6dB, & 12dB).
© 2008 directed electronics—all rights reserved
1 2 3 4
● DMM or VOM
Grommets
●
● Marking pen
Nylon tie straps
●
● Wire crimper
Wire cutters
●
● Wire strippers
5 6 7 8 9 10 11
3