RECORD YOUR SERIAL NUMBER AND DATE
To ensure your warranty (see back cover), please record the following information regard-
ing your new amplifier.
Model:
Serial Number:
Date of Purchase: __________________________________________________
Purchased from:
END PANEL LAYOUTS
HP-2300, HP-2400, HP-2600 Controls
HI INPUT
1.
Hi Input (high level input) - Accepts 1V to 10V input from the head unit's speaker
output. The amplifier will automatically wake-up when the input is greater than 1V.
High level input harness shown below.
2.
RCA Input - accepts RCA input from a head unit, preamplifier, or equalizer.
3.
RCA Line Output - provides easy connection to additional amplifiers.
4.
Gain Control - continuous adjustment for full power output.
5.
Intelli-Bass - continuously adjusts from 0 to 12dB of boost centered at 45Hz.
6.
Remote Bass Jack - connects optional HP-RB1 remote bass control to control the
bass level from the driver's seat. This control is only active when the crossover
switch is at the LPF setting.
7.
LPF (Low-Pass Frequency Control) - adjusts the frequency (50Hz–500Hz) of the
upper crossover frequency. When set for this position the optional remote bass
control is active.
8.
X-Over (cross-over) - activates LPF (low pass crossover), FLAT (all pass), or HPF
(high pass crossover).
9.
HPF (High-Pass Frequency Control) - adjusts the frequency (50Hz–500Hz) of the
lower crossover frequency.
10. Power LED - when illuminated (green) indicates that the amplifier is on.
Protect LED - when illuminated (red) indicates that the amplifier protective cir-
cuitry has been activated due to thermal, output short, supply undervoltage or
supply overvoltage.
© 2005 Directed Electronics, all rights reserved
__________________________________________________
__________________________________________________
__________________________________________________
1
2
3
4
5
INPUT
LINE OUT
L CH
L CH
GAIN
INTELLI-BASE
MIN
MAX
0dB
R CH
R CH
6
7
8
9
10
POWER
(GREEN)
REMOTE
LPF
X-OVER
HPF
PROTECT
(RED)
LPF
FLAT
HPF
12dB
50Hz
500Hz
50Hz
500Hz
3