Orion WCC 5001 User Manual page 8

5001–8001
1
PWR
( - ) ( - ) ( + )
1. PWR (LED blue) - when illuminated indicates that the amplifier is on.
2. HI Input (high level input) - Accepts 1v to 10v input from the headunit's speaker
output. The amplifier will automatically wake-up when the input is greater than
1V.
3. RCA Output - RCA output to another amplifier.
4. RCA Input - accepts RCA input from a source unit, preamplifier, or equalizer.
5. Level Control - continuously adjusts from 150mV to 5V for full power output.
6. Crossover Switch - activates low pass crossover, or full (all pass).
7. Low-Pass Frequency Control - adjusts the frequency (30Hz–250Hz) of the high-
pass crossover.
8. Bass - sets the bass boost of the high-pass crossover to 0, 6 or 12dB of boost.
9. PRT (LED red) - illuminates when the PRT (Protection) function is active. Activates
to protect the amplifier when the temperature is too high, the output has a DC
offset, a short was detected on the output, or the amplifier power cables have
been improperly connected (reverse power). If the temperature, DC offset, or
short condition has cleared after approximately 10-seconds the amplifier will
automatically recover.
10. Speaker Connections - accepts two speakers.
11. 2 ATC Fuses (25 amp) - protects the amplifier from over current situations.
12. Power Connections - accepts up to 8 AWG power and ground cables, and also
has a REM amplifier turn-on terminal (turns on the amplifier when fed +12 V).
© 2005 Directed Electronics—all rights reserved
2 3 4 5
OUTPUT INPUT
HI-INPUT LEVEL
1.5
3
L
5V
R
10 11
( + )
FUSE FUSE
6 7 8
PRT
X-OVER LOW PASS BASS
50
0.8
LPF FULL
0dB 12dB
0.15V 30Hz 250Hz 6dB
12
+12V REM GND
9
7