Garmin EDGE 520 PLUS Owner's Manual page 37

1
Select the band size that fits your
crank arm
CD
securely.
The band you select should be the
smallest one that stretches across the
crank arm.
2
On the non-drive side, place and hold
the flat side of the cadence sensor on
the inside of the crank arm.
3
Pull the bands
@
around the crank
arm, and attach them to the hooks
(3)
on the sensor.
4
Rotate the crank arm to check for
clearance.
The sensor and bands should not
contact any part of your bike or shoe.
NOTE: The LED flashes green for five
seconds to indicate activity after two
revolutions.
Quick Start Manual
5
Take a 15 minute test ride and inspect
the sensor and bands to ensure there
is no evidence of damage.
Installing the Speed Sensor
NOTE: If you do not have this sensor, you
can skip this task.
TIP: Garmin recommends you secure your
bike on a stand while installing the sensor.
1
Place and hold the speed sensor on
top of the wheel hub.
2
Pull the strap
CD
around the wheel
hub, and attach it to the hook
C2)
on the
sensor.
The sensor may be tilted when
installed on an asymmetrical hub. This
does not affect operation.
7