Leds - D-Link DVG-1120M Manual

LEDS

Power This LED is lit when
the device is receiving
power; otherwise, it is unlit.
Status/Alarm
This LED will remain green when the
CPE is either performing a self-test or
booting up. The LED will flash green
slowly when the system is ready for a
connection with the Call Agent. It will
remain red when the self-test or
booting up is failed. It will flash red
slowly when the system is ready but
cannot receive an acknowledgment
from the Call Agent.
Ethernet - This LED displays the
connection speed, link status, and
activity on the 10/100 dual-speed
Ethernet port that is used to connect
to your LAN.
10/100M - This indicator remains
unlit when there is no connection,
or the port is operating at 10Mbps
through a connection to a 10BASE-
T device. It is lit when the port is
operating at 100Mbps through a
connection to a dual-speed or
100BASE-TX Fast Ethernet
device.
Link/Act - When a good link to a
powered-up but idle device is
detected on a port, this indicator
shines steadily. When packets are
received from the device, the
indicator blinks off and on.
WAN This LED displays the
link status and activity on the
10M Ethernet port that is used
to connect to your WAN
device (usually a Cable or
ADSL Modem). When a good
link to a powered-up but idle
device is detected on a port,
the WAN indicator shines
steadily. When packets are
received from the device, the
indicator blinks off and on.
Phone 1 - This LED displays the
activity on the RJ-11 port that is
used to connect to your normal
telephone/fax machine line.
Hook/Ringing - When an off-
hook action is detected on a
phone port, this indicator shines
steadily. When a ringing signal
is received from the device, the
indicator blinks off and on.
7