Connections - D-Link DVG-1120M Manual

Connections

Reset Switch Used to return the device
to its original configuration. This is the
same as performing a factory reset.
AC Power Connector Use the
included power adapter. If you use
a power adapter other than the
one included with the product you
will damage the device and void
the warranty on this product.
PSTN/VoIP
Switch to
select PSTN
or VoIP mode
When the
switch is in
the down
position,
Phone1/2 will
be in VoIP
Mode.
When the
switch is in
the up
position,
Phone1/2 will
be configured
to PSTN
Mode.
Warning! Using a different power adapter than the
one included with your purchase will damage the
DVG-1120M and void the warranty.
Ethernet WAN
A 10Mbps
Ethernet port
fitted with an
RJ-45
connector used
to connect the
VoIP gateway
to a WAN
device (e.g.
Cable/ADSL
Modem). This
port accepts
Category 3, 4
or 5 UTP
cabling with an
RJ-45
connector.
Diagnostic Port An RJ-14
port used to configure the
device. (User needs a RJ-
14 to RS-232 converter).
Plug one end of a straight-
through wired RJ-14 cable
to the device and the other
end to a serial port of a PC
running a terminal
emulation program (such
as Microsoft HyperTerminal)
or a VT-100 terminal.
Ethernet LAN
A 10/100Mbps
dual-speed
Ethernet port
fitted with an
RJ-45
connector used
to connect the
VoIP gateway to
a LAN device
(hub, switch,
PC, etc.). This
port accepts
Category 5 or
better UTP
cabling with an
RJ-45
connector.
2 1
Phone 1
Normal RJ-11 phone
jack used to connect
to a telephone or fax
machine. Plug your
normal telephone or
fax machine directly
into this jack.
5