Restoring To Defaults (Reset) / Setting The Preferred Operating Mode - Yaesu FT-4VR Operating Manual

Restoring to Defaults (Reset) / Setting the Preferred Operating Mode

The following reset or preferred operating modes may be selected.
1. Turn the transceiver OFF.
2. Press and hold the MONI/T.CALL key and
the PTT switch simultaneously, while turning
the transceiver ON.
3. When the LCD backlight comes on, release
the MONI/T.CALL key and PTT switch.
4. Referring to the below table, press the [▲] or
[▼] key to select the desired resets or desired
operating modes.
5. Press the Function key momentarily to acti-
vate the selected operating mode.
Display
F1:SET RST
F2:MEM RST
F3:MB. RST
F4:ALL RST
F5:M-ONLY
F6:CLONE
Resetting the transceiver (F2 MEM RST / F4 ALL RST) will clear all
memories.
Always make a note of the memory channel settings, etc. before
resetting.
• To cancel this operation, turn the transceiver OFF.
• Perform F4:ALL.RST to restore all of the following Set Mode items to default.
10 DCS.COD 26 PSWD
35 SKIP
45 W/N.DEV
Resets the Set Mode settings to factory defaults.
Clears the Memory settings to factory defaults.
Clears the Memory Bank assignments.
Clears the all memories and other settings to factory defaults.
Memory Mode operation only.
Clone Mode.
CAUTION!
27 PSWDWT 30 RPT.FRQ 31 RPT.SFT
36 SQL.TYP 37 STEP
Description
38 TN FRQ 40 TX PWR
29