Mira Azora Installation And User Manual page 3

9. Installation of the shower must be carried out in accordance with
these instructions by qualified, competent personnel. Read all
instructions before installing the shower.
10. DO NOT switch the shower on if water starts leaking from the shower
case. Isolate the electrical supply to the shower immediately.
11. DO NOT switch the shower on if the case appears to be damaged
or incorrectly fitted. Isolate the electrical supply to the shower
immediately.
12. DO NOT increase the power setting or adjust the temperature
control rapidly while using the shower.
13. DO NOT switch the shower off and back on while standing in the
water flow.
14. DO NOT change the handset model. Fit only shower heads
recommended by Mira and do no fit any additional device to restrict
the water outlet flow.
15. When adjusting the handset mode, point handset away from body
and make sure that the water temperature has stabilised before
continuing to shower.
16. Use caution when altering the water temperature, always check
the temperature before continuing to shower.
17. S witch the shower off at the electrical isolating switch when not in
use. This is recommended with all electrical appliances.
18. Installation of the shower must be carried out in accordance with
these instructions by qualified, competent personnel. Read all
instructions before installing the shower.
19. Isolate the electrical and water supplies before commencing
installation. The electricity must be isolated at the consumer unit
and the appropriate circuit fuse removed, if applicable. Mains
connections are exposed when the cover is removed.
20. DO NOT install the shower in areas with high humidity and
temperature (i.e. Steam rooms and saunas).
21. DO NOT install the shower where it may be exposed to freezing
conditions. Ensure that any pipework that could become frozen is
properly insulated.
3 1062243-W2-N