Installation - Mira Azora Installation And User Manual

Installation

Installation of
Warning! Turn off the electrical and water supplies before proceeding with
the installation of the shower. The electricity must be turned off at the mains
and the appropriate circuit fuse removed, if applicable.
Note: An installation template is supplied to help you install the shower.
Wall fixings are not supplied. For solid wall structures a red rawl plug and a
no. 8 x 1½" countersunk brass or stainless steel screw should be used. For other
wall structures such as panels alternative fixings may be required. A minimum of 3
fixing screws should be used.
Remove the three cover retaining
screws, the cover and the service
tunnel.
Caution! Handle the glass
cover assembly with care.
Determine the direction and route
of the incoming water supply:
falling (entering the shower from
the top), or rising (entering the
shower from the bottom).
N ote: - D O N O T use an
Note: - DO NOT use an incoming
incoming supply entering the
supply entering the shower directly
shower directly from the back.
from the back. Add an elbow to the
Add an elbow to the supply
supply pipe and connect it as a
pipe and connect it as a rising
rising or falling supply.
or falling supply.
Swivel the inlet connector assembly
to suit. Remove the inlet blanking
cap. Avoid trapping the green earth
bonding wire.
1062243-W2-N
Mira Azora
Cover
12
Cover Retaining
Screw
Inlet
Connector