Table of Contents
Advertisement
Connecting The DI-808HV 8-Port Broad-
band VPN Router To Your Network
A.
First, connect the power adapter to the receptor at the back panel of the
DI-808HV and then plug the other end of the power adapter to a wall outlet or
power strip. The Power LED lights up indicating proper operation.
B.
1. Power off your cable or DSL modem; devices that do not have a on/off switch
will require you to unplug the power adapter. Now, the DI-808HV should be
powered on and the cable / DSL modem should be turned off.
cable / DSL modem
2.Connect an Ethernet cable to the Ethernet jack located on the cable / DSL
modem. After the Ethernet cable is securely connected, power on the cable / DSL
modem by turning on the unit or plugging in the power adapter.
cable / DSL modem
3. Insert the other end of the Ethernet cable to the WAN PORT on the back panel
of the DI-808HV. The WAN LED light will illuminate to indicate proper connection.
If the WAN LED is not illuminated, please check your Ethernet connection or go
back to step B1 and repeat the steps.
C.
Insert an Ethernet cable to
available Ethernet port on the network adapter in the computer you are using to
configure the DI-808HV. The LED light for LAN Port 1 illuminates to indicate proper
connection. (Note: The LAN Ports on the DI-808HV are Auto MDI/MDIX. Meaning
you can use a straight-through or crossover Ethernet cable in the LAN Ports.)
COM Port for dial-up Internet connection.
D.
C.
LAN PORTS
Ethernet cables to Ethernet enabled computers.
D.
COM Port
Used to
connect to an external
dial-up modem.
(Power
Off) – DI-808HV
(Power
On) – DI-808HV
LAN Port 1 on the back panel of the
These are the connections for
Reset Button
Pressing this button restores
the Router to its original factory
default settings.
(Power
On)
(Power
On)
B.
WAN PORT
for the connection of an
Ethernet cable to the
Cable or DSL modem
2
DI-808HV and an
This is
A.
Receptor for
Power
Adapter.
Advertisement
Table of Contents
