Chapter 2 Hardware Installation; Panel Layout - D-Link DI-704 User Manual

Chapter 2 Hardware Installation

2.1 Panel Layout

2.1.1. Front Panel
M1&M2
System status indicators, Orange. M1 is flashed once per second to
indicate system is alive. When system is busy, M2 is lighted.
WAN & LAN Ethernet port indicators, Green. The LED flickers when LAN or WAN port
is sending or receiving data.
Link/Act.
Link status indicators, Green. The LED flickers when the corresponding
port is sending or receiving data
10/100
10/100 status indicators, Green. The LED flickers when the corresponding
port is transmitting or receiving data in 10 or 100Mbps.
Port 1 - 4
LAN port socket (RJ-45). These are where you will connect to device on
your local area network, for example HUB and switch.
RESET
To reset system settings to factory defaults, please follow the steps:
1.
2.
3.
4.
5.
6.
Figure 2-1 Front Panel
Power off the device,
Press the reset button and hold,
Power on the device,
Keep the button pressed about 5 seconds,
Release the button,
Watch the M1 and M2 LEDs, they will flash 8 times and then
M1 flash once per second.
3