Servicing The Fuel Filter; Servicing The Cutting Blades - Toro 30326 Operator's Manual

5. Install the fuel line onto the fuel filter. Slide the hose
clamp close to the valve to secure the fuel line.
2
Figure 42
1. Fuel shut-off valve

Servicing the Fuel Filter

Service Interval/Specification
Replace the fuel filter after every 200 operating hours or
yearly, whichever occurs first.
Replacing the Fuel Filter
Never install a dirty filter if it is removed from the fuel line.
Note: Note how the fuel filter is installed.
Note: Wipe up any spilt fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Close fuel shut–off valve at fuel tank (Fig. 42).
4. Squeeze the ends of the hose clamps together and slide
them away from the filter (Fig. 43).
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps close to
the filter.
7. Open fuel shut-off valve at fuel tank (Fig. 42).
8. Check for fuel leaks and repair if needed.
1
m–5235
2. Clamp
34
1
3
1
2
Figure 43
1. Hose clamp
2. Fuel line

Servicing the Cutting Blades

To ensure a superior quality of cut, keep the blades sharp.
For convenient sharpening and replacement, you may want
to keep extra blades on hand.
Warning
A worn or damaged blade can break, and a piece
of the blade could be thrown into the operator's or
bystander's area, resulting in serious personal
injury or death.
Inspect the blade periodically for wear or
damage.
Replace a worn or damaged blade.
Before Inspecting or Servicing the Blades
Park the machine on a level surface, disengage the blade
control bail and set the parking brake. Turn the ignition key
to off. Remove the key and disconnect the spark plug
wire(s) from the spark plug(s).
Inspecting the Blades
1. Inspect the cutting edges (Fig 44). If the edges are not
sharp or have nicks, remove and sharpen the blades.
Refer to Sharpening the Blades on page 35.
m–7545
3. Filter