Installing The Fuel Tank - Toro 30326 Operator's Manual

4. Secure the handle at each lower mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 4).
Note: The handle position can be adjusted to match the
operator's height preference.
4
6
1
3
7
8
Figure 4
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
Note: Handle assembly must be installed before fuel tank is
installed.
5
2
m–6403
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
15
Step
3

Installing the Fuel Tank

Parts needed for this step:
Qty.
1
Fuel tank with studs installed
2 Bolt, 5/16 X 7/8 inch
2 Lock nut, 5/16 inch
4 Washer, 5/16 inch
1 Hose clamp
2 Lock washer, 5/16 inch
2 Spring
Procedure
1. Align fuel tank with the top of the rear frame (Fig. 5).
2. Secure the right side of the fuel tank to the rear frame
with 2 bolts (5/16 x 7/8 inch), lock washers (5/16 inch)
and washers (5/16 inch) (Fig. 5).
3. Secure the left side of the fuel tank to the rear frame
with 2 studs, washers (5/16 inch), springs and locknuts
(5/16 inch) (Fig. 5).
Note: Tighten left side of the fuel tank until it is completely
tight and then unscrew locknut one full turn. This will
allow the spring to work.
Part