Table of Contents
Advertisement
Step
1
Removing the Shipping
Bracket
Parts needed for this step:
None
Procedure
1. Remove the center gage wheel nut, 2 large washers,
angle bracket and 1 small washer (Fig. 4). Discard the 2
large washers and the angle bracket.
1
3
4
Figure 2
1. Center Gage Wheels and
Spacer
2. Nut
2. Install the center gage wheels with the previously
removed bolt, small washer and nut (Fig. 3).
5
3
2
m–7585
3. Large washer—discard
4. Angle bracket—discard
5. Small washer
14
3
4
1
Figure 3
1. Center Gage Wheels and
Spacer
2. Nut
Step
2
Installing the Handle Assembly
Parts needed for this step:
Qty.
1
Handle assembly
4
Flanged bolt, 3/8 x 1 inch
4
Flange nut, 3/8 inch
Procedure
1. Align handle with upper mounting holes in rear frame
(Fig. 4).
2. Secure the handle at each upper mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 4).
3. Select the low position for the lower mounting hole
(Fig. 4).
4
2
m–6510
3. Bolt
4. Washer
Part
Advertisement
Table of Contents
