Table of Contents
Advertisement
Adjusting the Gage Wheels
The gage wheels need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) minimum clearance above the ground.
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Figures 23 and 24).
2. If adjustment is needed, remove the bolt, washer(s) and
nut (Figures 23 and 24).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figures 23 and 24).
4. Install the bolt, washer(s) and nut (Figures 23 and 24).
2
4
1
Figure 23
1. Gage wheel
2. Nut
3. Bolt
3
5
m–6470
4. Washer
5. Spacer
24
3
4
1
Figure 24
1. Center Gage Wheels and
Spacer
2. Nut
Adjusting the Handle Height
The handle position can be adjusted to match the operator's
height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Fig. 25).
6
1
3
Figure 25
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 26).
4
2
m–6510
3. Bolt
4. Washer
4
5
2
m–7593
4. Washer
5. Hairpin cotter pin
6. Rod fitting
Advertisement
Table of Contents
