Table of Contents
Advertisement
6. Description and Characteristics
1.
This 125DV portable band saw is made as
light as 21 kg by weight for your fitness to
transport to any worksites.
2.
This machine frame is cast by the
aluminum. The base formed by the steel so
that body construction becomes stronger
and smoother.
3.
During operation, the noise level of this
machine is about 60 db, which is much less
than any of the other band saws, and of
course, it can present a comfortable
working environment.
4.
This machine is made ready for the blade
tension adjustment by holding the handle to
give a little turn for the tension increasing,
or decreasing as you wish during the
period of blade replacement or machine in
operation. Also attached compression
spring that for reducing vibration that is
from a defective work piece popping while
machine is running. It permits the blade to
be used much longer.
5.
The drive of this machine is through gear
transmission that gives steadier, stronger,
and smoother cuts superior to any of pulley
drive band saws, and make less trouble
after service. Note: If anything unusual
happens on your gear transmission system,
do not try to fix or restore it personally.
Send it back to your dealer for check-up or
repair. Failure to comply can result in
machine damage.
6.
The machine combines miter, and
horizontal cutting and is designed for full
efficiency and operator convenience in
each position.
7.
An auto shutoff assures the complete cut,
thus permitting unattended operation.
SHUT OFF THE POWER SOURCE ALL THE
TIME, BEFORE THIS MACHINE IS IN
MAINTENANCE, OPERATION, ADJUSTMENT,
OR REPAIRMENT.
Disconnect machine from the power source!
No matter when, where, or how. Pay extra
attention to the saw during it in transportation,
operation, maintenance, or adjustment.
Failure to comply may cause serious injury!
WARNING
WARNING
7. Operating
Information before Operation
Be sure the blade isn't in contact with the work
when the motor is started.
Run the motor allow the saw to come to full
speed. Begin the cut by letting the head down
slowly onto the work.
DO NOT DROP. Use the handle of trigger switch
operating by hand.
Press green button down (Fig. 5) to turn on the
power and press and hold the trigger switch
(FIG.6) for manual cutting.
Finished cutting or stop the cutting by press
down the red button or release the trigger
switch.
ON/OFF switch
Trigger switch
Manual Cutting
Feed Rate by Handle with Trigger
Switch
Push down the handle of trigger switch in for
cutting material by hand.
- 7 -
Fig. 5
Fig. 6
Advertisement
Table of Contents
