Table of Contents
Advertisement
6
INSTALLATION
6.1
Warnings
The use of gas appliances is
subject to statutory control; it is
essential to observe the current
regulations and laws in force
(see also chapter 5).
The appliance must discharge
combustion products directly
outside or into a suitable ex-
haust duct designed for this
purpose. Combustion products
must be discharged using origi-
nal flue kits only, since they are
integral parts of the boiler.
For Propane, the appliance must also con-
form with the requirements of the distribu-
tors and comply with current Regulations
and laws in force.
The safety relief valve and the condensate
drain must be connected to a suitable drain,
or discharge in a safe manner.
The electrical wiring must conform with cur-
rent Regulations, in particular:
• The Aoiler must be earthed using the cor-
rect bonding clamp.
• a fused spur isolation switch, with a gap of
at least 3 mm between the contacts must
be installed near to the boiler.
Refer to section "Electrical connections"
to page 42 in this chapter for the electrical
connections.
In no circumstances will the manufac-
turer be held responsible if the warnings
and instructions contained in this manu-
al have not been complied with.
- 36 -
INSTALLATION
6.2
• The boiler must be fixed to a strong wall.
• The dimensions for the exhaust fume duct
(detailed in section "Choice of flue" to
page 38) and the correct procedures for
installing the duct, depicted in the instruc-
tion leaflet included with the flue kit, must
be complied with during installation.
• To allow maintenance procedures it is
necessary to leave the minimum gaps in-
dicated in Fig. 6.1.
Fig. 6.1
• When installing the boiler in a cupboard,
cover or alcove allow at least 50 mm per-
manent clearance from the front face of
the boiler. Also ensure sufficient clearance
to allow free access for servicing and the
lowering of the front control panel.
• If the boiler is installed outside, cover the
appliance to protect it against the ele-
ments and add some special anti-freeze
(neutralised) to the c.h. system.
Precautions for installation
For the installation proceed as
follows:
250
25
200
All measures are in mm
25
Advertisement
Table of Contents
