Lighting Instructions - Napoleon BILEX730 User Manual

8

Lighting Instructions

WARNING!
WARNING!
valve.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position
and wait 5 minutes for any excess
gas to dissipate. Either repeat steps
2 and 3 or light with a match.
5. If lighting the unit with a
match, clip the match into the
supplied lighting rod. Hold the
lit match down through the grill
and sear plate while turning the
corresponding burner valve to high.
WARNING!
Unless all burners are turned off prior to turning the cylinder on, only small flames and low heat will be
achievable.
WARNING!
www.napoleongrills.com
Lights
Left Rear
Burner Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Burner
Lighting
1. Open grill lid.
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame
which will in turn light the burner. If
the pilot lights, continue to push down
on the burner control knob until the
4. If the burner does not ignite, then
immediately turn the control knob
back to the 'off' position and repeat
5. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 3 and 4 or light with a match.
The Universal Liquefied Petroleum Gas cylinder is equipped with an excess flow device.
Do not use the rear burner (rotisserie burner) with the main burners operating.
Left Centre Centre Right Centre
Burner Burner Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
burner lights then release.
step 3 several times.
Infra Red
Burner
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner control to
high position.
3. Press and hold igniter button until
burner lights, or light by match.
4. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.