Table of Contents
Advertisement
SAFETY INFORMATION
This digital set-top has been manufactured and tested with your
safety in mind. However, improper use can result in potential
electric shock or fire hazards. To avoid defeating the safeguards that
have been built into your set-top, please observe the precautions
discussed in this document.
Warnings on your set-top
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol, within a
triangle, is intended to alert you to the presence of
uninsulated "dangerous" voltages within your set-top's
enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within a triangle is intended to
alert you to the presence of important instructions in
the literature accompanying your set-top.
Other warnings
To reduce the risk of electric shock, do not remove the cover of
your set-top. There are no user-serviceable parts inside it.
Do not perform any servicing unless you are qualified to do so.
Refer all servicing to qualified service personnel. Servicing the set-
top yourself will invalidate the warranty.
To reduce the risk of fire or electric shock, do not expose this set-
top to rain or moisture.
On the rear panel of your set-top there is a tamper-evident label
that states 'Warranty void if broken or removed'.
To avoid possible damage to the internal hard disk, do not pick up
or otherwise move your set-top while it is connected to the power
supply. If you want to move your set-top, first disconnect it, then
wait at least 30 seconds before continuing. You should handle your
set-top carefully, as any damage you cause to the internal hard disk
(or any other component) will invalidate your warranty.
Installation
The installation of your set-top should be carried out by a qualified
installer and should conform to local codes.
Note to the installer
This reminder is provided to call the attention of the cable-TV-system
installer to Section 820-40 of the National Electrical Code (USA),
which provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as is practical.
Service address:
Pace Micro Technology (Support Services) Ltd.
3701 FAU Boulevard, Suite 200, Boca Raton
Florida, 33431, U.S.A.
Advertisement
Table of Contents
