Auto Power-Off After The End Of Broadcast; Auto Power-Off When There Are No Operations Performed; Quick Start; Picture Size Settings - Sharp Aquos LC-40LB700X Operation Manual

Watching TV

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving no
programme signals, such as the end of a broadcast day.
Press MENU and the MENU screen displays.
1
Press c / d to select "ECO".
2
• ECO menu displays.
Press a / b to select "No signal off", and then
3
press ENTER.
Press c / d to select "Enable", and then press
4
ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme finishes, this function may not operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
Press MENU and the MENU screen displays.
1
Press c / d to select "ECO".
2
• ECO menu displays.
Press a / b to select "No operation off", and
3
then press ENTER.
Press a / b to select "30min." or "3hr.", and
4
then press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.

Quick start

You can reduce the TV's start-up time after turning on
the power with the remote control unit.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Quick start", and then
3
press ENTER.
Press c / d to select "On" or "Off", and then
4
press ENTER.
Selected item
On The TV quickly starts up from standby,
19 W or more of power consumption is
required during standby.
Off Power consumption is less than 1 W.
LC-40LB700X_en_d.indd 33 LC-40LB700X_en_d.indd 33
Description

Picture size settings

Selecting the Wide Screen Signalling
(WSS) picture size automatically
WSS allows a television to switch automatically among
the different screen formats.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "WSS", and then press
3
ENTER.
Press c / d to select "On" or "Off", and then
4
press ENTER.
NOTE
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
Selecting the Wide Screen Signalling
(WSS) picture size manually
The WSS signal has 4:3 auto-switching that allows you
to select between Panorama and Normal.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "4:3 mode", and then
3
press ENTER.
Press c / d to select "Panorama" or "Normal",
4
and then press ENTER.
WSS signal 4:3 screen
4:3 mode "Panorama"
Selected item
Panorama Wide image without side bars
Normal Normal range keeping 4:3 or 16:9 aspect
ratio
4:3 mode "Normal"
Description
33
8/7/2009 12:36:39 PM 8/7/2009 12:36:39 PM