Disc Playback; Loading A Disc; Removing A Disc - Sharp Aquos LC-40LB700X Operation Manual

Disc Playback

This section explains playback of commercially
available BD-VIDEO and DVD-VIDEO discs (like
movies), CDs, and recorded DVD-RW/R discs.

Loading a Disc

Insert the disc into the disc slot.
• The label side of the disc must face towards the front of the
TV (towards you).
• When inserting a dual-sided DVD, the side you want to play
must face towards the rear of the TV (away from you).
r
L
I
s
k
l
• When the disc is loaded, the DISC indicator lights up.
• Playback may begin automatically, depending on the disc.
• The menu may be displayed fi rst, depending on the disc.
Perform playback operation by following the directions on
the screen.
NOTE
• In the following cases, the disc will be ejected automatically.
– When a disc using an incompatible standard or format
was inserted.
– When the disc was inserted facing the wrong way.
56
LC-40LB700X_en_g.indd 56 LC-40LB700X_en_g.indd 56
Disc slot
The label side of the disc

Removing a Disc

Press on the TV or EJECT on the remote
1
control unit.
r
L
s I
k
l
• The disc is ejected and protrudes partly from the
slot.
Carefully grasp the protruding disc and pull it
2
out.
r
s
k
l
• After a disc has been ejected, it should be removed
from the slot without delay.
NOTE
• If the TV is jolted or moved while a disc is protruding from
the slot, the disc may fall out.
• To reinsert a protruding disc, fi rst remove the disc fully and
then load it again.
• During loading, the disc may be unable to be ejected. Wait
until the loading is complete and playback starts to eject
the disc.
L
I
8/7/2009 12:37:50 PM 8/7/2009 12:37:50 PM