Ricoh WG-30W Operating Manual page 36

3
Insert the DC coupler.
Using the side of the DC coupler to push the battery lock lever, insert the DC
coupler. Confirm that the DC coupler is locked in place.
The battery/card cover will not close while the DC coupler is inserted. Leave the
1
cover open when using the AC adapter and do not attempt to close it.
4
Connect the DC terminal of the AC adapter to the DC terminal
of the DC coupler.
5
Connect the AC plug cord to the AC adapter.
6
Plug the AC plug cord into the power outlet.
• Make sure that the camera is turned off before connecting or disconnecting
the AC adapter.
• Make sure that the AC plug cord and the DC terminal connecting the AC
adapter to the camera are inserted securely. Data may be lost if either
becomes disconnected while the data is being recorded on the SD Memory
Card or in the built-in memory.
• Use the AC adapter with due care to avoid fire or electric shock.
Be sure to read "About the Power Adapter and the AC Adapter" (p.3) before
using the AC adapter.
• Be sure to read the operation manual accompanying the AC adapter kit K-
AC117 before using the adapter.
• When connecting the AC adapter, you cannot set the camera upright on the
table because the cord from the DC coupler comes out of the bottom of the
camera.
• Do not use excessive force when sliding the battery/card cover open and
closed because the waterproof seal may peel off. If the seal is not in the
correct position, the camera will not be waterproof.
34