Simpson MSV2623 Instruction Manual page 14

4. After use of chemicals, place detergent siphon hose into container of clean
water and draw clean water through chemical injection system to rinse system
thoroughly. If chemicals remain in the pump it could be damaged. Pumps
damaged due to chemicals will not be covered under warranty.
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed
on the spray wand.
To Apply chemicals (mSV3025):
1. Fill your detergent tank (L, Figure 7B) with
pre-mixed cleaning solutions designed for
pressure washer use.
2. Check and make sure the valve (R) for the
tank is in the OPEN" position. NOTE: For
every 7 gallons of water pumped 1 gallon of
chemical/cleaning solution will be used.
3. Install low pressure (black) nozzle into quick connect fitting of spray wand, see
how To use Spray wand paragraph in this section.
4. After use of chemicals, refill your detergent tank with clean water and operate
your chemical injection system to rinse it thoroughly. If chemicals remain in
the pump it could be damaged. Pumps damaged due to chemicals will not be
covered under warranty.
NOTE: After use turn valve (R) to CLOSED position.
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed
on the spray wand.
STARTING (FIG. 8–11)
WARNING: To reduce the risk of injury, read the pressure washer instruction
manual and the engine instruction manual before starting pressure washer.
DANGER: Risk of fluid injection and laceration. When using the high-
pressure setting, DO NOT allow the high-pressure spray to come in contact
with unprotected skin, eyes, or with any pets or animals. serious injury will
occur.
• Your washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician
immediately!
WARNING: Risk of fire, Asphyxiation and burn. Never fill fuel tank when
engine is running or hot. Do not smoke when filling fuel tank.
• Never fill fuel tank completely. Fill tank to 1/2" )12.7 mm) below bottom of filler
neck to provide space for fuel expansion. Wipe any fuel spillage from engine and
equipment before starting engine.
• Never run engine in d oors or in en c losed, poorly ven t i l at e d areas. En g ine exhaust
con t ains carbon mon o x i de, an odorless and deadly gas.
• DO NOT let hoses come in contact with very hot engine muffler during or
immediately after use of your pressure washer. Damage to hoses from contact with
hot engine surfaces will NOT be covered by warranty.
NOTIcE: Risk of property damage. Never pull water supply hose to move pres sure
washer. This could damage hose and/or pump inlet.
7b
14- ENG
R
L