Page 1
Failure to follow the instructions and safety precautions in this manual can result in property damage, serious injury and/or death. SAVE THIS MANUAL FOR FUTURE REFERENCE NOTE: Photographs and line drawings used in this manual are for reference only and may not represent your specific model. MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Nozzle Installation ...................... 12 USING CHEMICALS ..............13 OPERATING CHECKLIST ............14 Location ........................14 High Altitude Operation ....................15 Operating Conditions....................15 Checking the Engine Oil ..................... 16 Checking Fuel ......................18 Page 2 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Page 3
Storing for Two Months or Less .................. 26 Storing for More Than Two Months ................27 Transportation ......................27 WARRANTY INFORMATION ............28 Limited Warranty ......................28 Limited Warranty (Continued) ..................29 Page 3 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Indicates a hazardous situation, which if not avoided, could result in property damage and/or minor to moderate injury. Indicates information considered important, but not directly hazard related. Page 4 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
● This manual may cover more than one machine. The pictures and figures in the manual should be used for reference only. There may be differences between your product and the pictures, drawings, and diagrams in this manual. Page 5 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Slide the handle onto the frame then secure it with the included knobs and bolts. Install button-style handle Press and hold buttons then slide handle onto frame until buttons click into place. Page 6 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
To avoid these hazards, be sure to read, understand, and follow the steps outlined in the OPERATING CHECKLIST section of the owner’s manual before starting the engine, and follow all the guidelines for proper use of the pressure washer. Page 7 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Then, turn off the water supply and thread the water supply hose into the pump inlet. Thread the high-pressure hose onto the pump outlet. Thread the high-pressure hose onto the spray gun. Page 10 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Never attempt to touch a leak in a high-pressure hose or fitting. Never attempt to repair a high-pressure hose. Page 11 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
To place a nozzle into the spray wand, pull the quick-connect coupler back, insert the nozzle, then release the coupler allowing it to snap back in place. Once installed, pull on the nozzle to make sure it secure. Page 12 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
If soap or other chemicals remain in the pump, the pump could be damaged. Pump damage from soap or chemical residue is not covered under warranty. Page 13 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
20 feet (6 meters) away from windows, doors, and vents. Carefully consider wind direction and air currents when using this product outside to avoid breathing in engine exhaust. Always use a carbon monoxide detector in any occupied buildings near the running engine. Page 14 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Keep young children and pets away from the pressure washer while it is running. Always turn off the pressure washer before leaving the area. Page 15 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
The low oil sensor (if equipped) will automatically stop the engine when the oil level falls below the safe limit. To avoid an unexpected shutdown, check the oil level regularly, fill to the upper limit, and always operate engine on a level surface. Page 16 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Page 17
See the engine manual for recommended oil. Install the dipstick and tighten cap by threading it into the filler neck. Upper Oil Limit Lower Oil Limit Engine Oil Dipstick Page 17 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
To avoid these hazards, always allow the engine to cool for at least 2 minutes before removing fuel cap and loosen the fuel cap slowly to relieve any pressure in the tank. Page 18 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Page 19
NOTE: Using a fuel stabilizer (sold separately) when storing gasoline can help prevent problems related to storing ethanol alcohol blended gasoline. Always follow the instructions provided by the fuel stabilizer manufacturer to mix and use correctly. Maximum Fuel Level Page 19 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
NOTE: The starting position of the choke will vary depending on the engine temperature. If starting a cold engine, move the choke lever towards the closed position. If starting a warm engine, move the choke lever towards the open position. CLOSED OPEN Page 20 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Turn the ignition switch to the OFF position. Turn off the water supply. Squeeze the spray gun trigger to relieve the pressure in the hose and pump. Allow the engine to cool completely before handling and storing. Page 21 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
● Start washing siding at the bottom and work your way up, then rinse from the top down. ● Avoid driving water up behind siding. ● Use overlapping strokes for even cleaning. ● Work in smaller areas and do not let soap dry on surfaces. Page 22 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Clean the water The water inlet screen is inlet screen per the clogged. MAINTENANCE section of this manual. The high-pressure hose The high-pressure hose is should be less than 100 too long. feet long. Page 23 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Connections Hose, spray gun, and pump connections should be cleaned and lubricated with a thin film of lithium grease regularly to prevent o-ring damage and leaks. Page 24 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Remove the filter from the pump inlet. Use a water from a running garden hose to clean both sides of the filter. Insert the cleaned filter into the pump inlet with the convex side facing out. Page 25 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Allow the engine to cool completely. Using SIMPSON Pump Guard or an equivalent is recommended when storing the unit for more than 30 days and/or when freezing temperatures are expected. Store the pressure washer in a clean, dry area out of direct sunlight.
Install the spark plug. Drain the high-pressure hose. Using SIMPSON Pump Guard or an equivalent is recommended when storing the unit for more than 30 days and/or when freezing temperatures are expected. Store the pressure washer in a clean, dry area out of direct sunlight.
The manufacturer will not be liable to any persons for consequential damage, for personal injury, or for commercial loss. Page 28 MS61220/MS61221- ENGLISH REV 2 - 01/03/2022...
Page 29
RESPONSIBILITY OF ORIGINAL PURCHASER (INITIAL USER): To process a warranty claim on your SIMPSON® pressure washer, report the concern to 1-877-362-4271 or cservice@fna-group.com for authorization and direction to the nearest authorized service center in your area Retain original cash register sales receipt as proof of purchase for warranty work...