Troubleshooting Guide - Daewoo DWM-7010 Service Manual

5. TROUBLESHOOTING GUIDE

NOTES
Pull out the power plug to repair and make sure that the Washing Machine has been properly
grounded.
C o n c e rning Wash
PROBLEM
Is the Power properly connected?
Is the Fuse blown?
Is there a whirring sound from the
Wash Motor when turned on?
Agitator
does not
NO
rotate.
Is the Motor hot?
(In case there is Thermal Protector)
Is the Wiring good?
(Refer to the Wiring Diagram)
Is the connact of Wash Timer good?
Is the Wash Load appropriate?
Are the Agitator and Motor Pulleys
securely assembled?
Agitator
does not
rotate
smoothly.
Does the V-Belt slip?
Are there impurities between the
Agitator and Tub.
11 CONVENIENCE
CHECK POINT
YES
NO
YES
Is the of Condeser properly
connected?
NO
YES
YES
YES
YES
YES
NO
CAUSE
NO
YES
NO
Motor does not start due to
opening the Condenser circuit
YES
Power has been cut off by
the Thermal Protector.
NO
Improper wiring
NO
Defective Wash Timer
Defective Wash Motor
NO
NO
Defect of mechanical
assembly
YES
Worn out V-Belt
YES
Revolution obstructed by
impurities
SOLUTION
Reconnect the Power Cord.
Change the Fuse.
Reconnect the Condenser.
Power restored when
Motor cools
Reconnect the wiring
Replace Wash Timer
Replace Wash Motor
Reload with proper wash
load.
Tighten the screws fixed on
the Pulleys.
Replace V-Belt
Remove impurities after
disassembling Agitator