Advertisement
This wahing machine is equipped with automatic safety function which detect and diagnose faults at an
early stage and react appropriately.
When the machine does not function properly or does not fuction at all, check the following points.
Problem
Program dose not start.
Water dose not enter
the washing machine.
Washing machine is
not drain.
Washing machine is
not spin.
Spin result is unsatis-
factory.
Foam come out of the
detergent case.
Serious noise and
vibration.
9 . TROUBLESHOOTING GUIDE
Cause
Plug is loose or not plugged in.
Power failure.
Loading door is not closed.
Program is not selected.
Start/Pause button is not pressed.
Water tap is not turned on.
Inlet hose is kinked or folded.
Filters is blocked in water inlet
filter.
Drain hose is kinked or clogged.
Pump filter is clogged.
The amount of laundry is too
small.
The laundry is unbalanced.
Drain hose is placed over 1m
above the floor.
Too much detergent or unsuit-
able detergent used.
Transit bolts are not removed.
Washing machine is installed
on uneven floor.
Washing machine is not lev-
eled.
Solution
Insert plug tightly.
An interrupted program will be resumed when the
power return.
Check whether laundry is trapped in door.
Close the loading door. (a click should be heard)
Select the desired program.
Press the Start/Pause button.
Turn the water tap on.
Straighten the inlet hose.
Clean the water inlet filter.
Straighten and clean the drain hose.
Clean the pump filter.
Add the laundry to balance. And repeat the Spin
cycle.
Rearrange the laundry. And repeat the Spin cycle.
If articles of heavy clothing (e.g. bath robe) are
loaded, washing machine may skip or stop the
spin cycle.
Place the drain hose under 1m above the floor.
Repeat the Rinse cycle.
Remove the transit bolts.
Reinstall washing machine on even floor.
Adjust the level of washing machine using
adjustable legs.
TROUBLESHOOTING GUIDE
29
Advertisement
