Maintenance - Chicago Electric 62297 Owner's Manual & Safety Instructions

Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM AccIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Page 16 For technical questions, please call 1-888-866-5797.
3. Remove the Pad from the tool when not in use.
This will allow the Pad to dry and retain its
original shape. The Pads may be machine-
washed in cold water with detergent.
Then machine-dry the Pads at medium heat.
4. Periodically, wear ANSI-approved safety goggles
and NIOSH-approved breathing protection
and blow dust and grit out of the motor
vents using dry compressed air.
5. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Item 62297