Table of Contents
Advertisement
Troubleshooting
58
Problem
The oven door does not open
after a Self Clean cycle.
The display shows
cannot open the oven door or
adjust the time.
The display shows Fdor
The display shows Fdor when
I do a test Self Clean after
removing the door for cleaning.
I replaced the door after cleaning
but it does not shut properly.
Possible solutions
The oven is too hot for the door to be
opened safely.
When the oven has cooled to a safe
temperature the door will automatically
unlock and the door lock indicator will go out.
12.00
There has been a power interruption during
and I
a Self Clean cycle.
When the power is restored the door will
remain locked until the oven has cooled to
a safe temperature.
When the oven has cooled the door will
unlock and the display will flash 12.00.
You can then reset the clock and use the
oven.
The door has not shut completely (Self clean
function) or the Self Clean function has failed.
Close the door firmly and try re-starting
the Self Clean cycle.
If the display still shows 'Fdor' try turning
off the oven at the wall. If the error persists
when you turn it back on, call Customer
Care or your Authorised Service Centre.
The door has been incorrectly replaced after cleaning.
Remove and replace the door and retest. It the error
still persists call Customer Care or your Authorised
Service Centre.
The door lock is obstructing the door.
Remove and replace the door again. If this does not
help, call Customer Care or your Authorised Service
Centre.
Advertisement
Table of Contents
