Set The Switch Date And Time - TRENDnet TEG-160WS User Manual

TRENDnet User's Guide

Set the switch date and time

System > System Time
1. Log into your switch management page (see
on page 7).
2. Click on System, and click on System Time.
3. Review the settings. Click Apply to save changes.
• Clock Mode - Displays if system time and date is set manually Local Time or
obtained automatically from a network time server SNTP.
• Current Time – Displays the current system time and date.
•
Time Zone – Displays the current system time zone.
•
Clock Mode: Select Local Time to manually configure your date and time
settings or select SNTP to configure your switch to automatically obtain
settings from an network time server.
Local Time – Allows you to manually set the time settings. If selecting
o
this option, under Local Time Settings, manually enter your date and
time settings.
Date Settings – Enter your date settings (YYYY/MM/DD).

Time Settings – Enter your time settings (HH:MM:SS)

© Copyright 2014 TRENDnet. All Rights Reserved.
"Access your switch management page"
SNTP – Allows you to configure your switch to pull time and date
o
settings automatically from a network time server. If selecting this
option, under Simple Network Time Protocol (SNTP) Settings, enter
your time server settings.
Note: Please note that in order for the switch to communicate to
Internet SNTP time servers, the switch must have valid IPv4/IPv6
address settings including a default gateway address for Internet
access. Additionally, if using a domain name, the switch must be
configured with valid DNS server settings in order to resolve
host/domain names.
SNTP Primary Server – Enter the primary network time server

IPv4 address, IPv6 address, or Domain Name.
SNTP Secondary Server – Enter the secondary network time

server IPv4 address, IPv6 address, or Domain Name..
 SNTP Poll Interval – Enter the interval time when your switch
will update the time and date settings with the time server.
Time Zone – Click the drop-down list to select your time

zone. Additionally, you can set your Daylight Savings Time.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK. Note: This step saves all
configuration changes to the NV-RAM to ensure that if the switch is rebooted or power
cycled, the configuration changes will still be applied.
TEG-160WS
17