Table of Contents
Advertisement
Scan monitors for signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel
and only stops if a matching signal is present.
To start/stop scanning, press the key programmed as [Scan].
•
The
indicator appears during Scan.
•
When a signal is detected, Scan pauses at that channel. The
transceiver will remain on the busy channel until the signal is no
longer present, at which time Scan resumes.
Note: To use Scan, there must be at least 2 channels added to the
scanning sequence.
PrIorITy SCAN
If a Priority channel has been programmed, the transceiver
will automatically change to the Priority channel when a call
is received on that channel, even if call is being received on a
normal channel.
•
The
indicator appears when the selected channel is the Priority
channel (depending on dealer setting).
TEMPorAry CHANNEl loCKoUT
During scan, you can temporarily remove specific channels
from the scanning sequence by momentarily pressing the key
programmed as [Scan Delete/Add] while Scan is paused at
the undesired channel. To temporarily remove a zone, press
and hold the [Scan Delete/Add] key while Scan is paused at a
channel in the undesired zone.
•
The channel/zone is no longer scanned. However, when scanning
is ended and restarted, the Scan settings return to normal.
SCAN
3
Hide quick links:
Advertisement
Table of Contents
