Integra DTR-40.2 Instruction Manual page 73

5
When you've finished, press Return.
The save confirmation screen appears.
7-6. Network
Save
Cancel
6
Use q/w to select "Save", and then press Enter.
When modifying network settings, after modifying it
is necessary to execute "Save".
7
When you've finished, press Setup.
The setup menu closes.
Note
• This procedure can also be performed on the AV receiver by
using its Setup, arrows, and Enter.
■
Mac Address
This is the AV receiver's MAC (Media Access Control)
address. This address cannot be changed.
■
DHCP
This setting determines whether or not the AV receiver
uses DHCP to automatically configure its IP Address,
Subnet Mask, Gateway, and DNS Server settings.

Enable:
DHCP enabled.

Disable:
DHCP disabled.
If you select "Disable", you must configure the "IP
Address", "Subnet Mask", "Gateway", and "DNS
Server" settings yourself.
■
IP Address
If you set the "DHCP" setting to "Disable", you must
specify an IP address. Enter a static IP address provided
by your ISP.
The IP address must be within the following ranges.

Class A:
10.0.0.0 to 10.255.255.255

Class B:
172.16.0.0 to 172.31.255.255

Class C:
192.168.0.0 to 192.168.255.255
Most routers use Class C IP addresses.
■
Subnet Mask
If you set the "DHCP" setting to "Disable", you must
specify a subnet mask address.
Enter the subnet mask address provided by your ISP (typi-
cally: 255.255.255.0).
■
Gateway
If you set the "DHCP" setting to "Disable", you must
specify a gateway address.
Enter the gateway address provided by your ISP.
■
DNS Server
If you set the "DHCP" setting to "Disable", you must
specify a DNS server.
Enter the DNS server addresses provided by your ISP.
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you're using a Web proxy, enter a proxy port number
here.
■
Control
This setting enables or disables control over the network.
Enable:
Control over the network enabled.
Disable:
Control over the network disabled.
Note
• When set to "Enable", power consumption on standby mode
increases.
■
Port Number
This is the network port used for control over the network.
Note
• Set the port number between from "49152" to "65535".
En
73