Integra DTR-40.2 Instruction Manual page 37

Displaying SIRIUS Satellite Radio
Information
Press Display repeatedly to cycle through the
available information.
The following information can be displayed:
Channel name and Channel number
Category
Artist/composer
Song title
Listening mode
Note
• If the category, artist/composer, or song title is not available,
"- - -" will be displayed instead.
Positioning the SiriusConnect Home
Antenna
You can check the strength of the SIRIUS Satellite Radio
signal and adjust the position of the SiriusConnect Home
antenna accordingly.
1
Press Receiver followed by Tuner, and Setup.
The main menu appears onscreen.
2
Use q/w to select "Hardware Setup", and then
press Enter.
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto Power Down
6. Network
7. Firmware Update
Note
• If the "SAT Radio Mode" setting is set to "None"
(➔ 33), the "Antenna Aiming" setting is not available.
3
Use q/w to select "Tuner", and then press Enter.
4
Use q/w to select "Antenna Aiming", and then
press Enter.
The signal strength meter and your SIRIUS Satellite
Radio ID are displayed.
5
Position the SiriusConnect Home antenna so that
as many bars as possible (up to 3) appear on the
Satellite signal strength meter.
Antenna Aiming
SIRIUS
Satellite
SIRIUS ID
If you cannot receive a satellite signal, position the
SiriusConnect Home antenna so that as many bars as
possible (up to 3) appear on the Terrestrial signal
strength meter.
Note
• So long as the signal strength is good, you can enjoy SIRIUS
Satellite Radio by using either satellite or terrestrial reception.
• Terrestrial signals are only available in certain areas.
• The SIRIUS information on the Satellite Radio screen is only
displayed when the "SAT Radio Mode" setting is set to "SIR-
IUS" (➔ 33).
SIRIUS Satellite Radio Messages
The following messages may appear while using SIRIUS
Satellite Radio.
■
ACQUIRING SIGNAL
The SiriusConnect receiver is acquiring the signal or no
signal is present. Make sure the SiriusConnect Home
tuner is connected properly and that there are no obsta-
cles nearby.
■
ANTENNA ERROR
Make sure the SiriusConnect Home tuner is connected
properly.
■
SUBSCRIPTION UPDATED
Displayed while your subscription is being updated. No
operations can be performed until this message has
cleared.
■
UPDATING CHANNELS XXX%
Displayed while the channel map is being updated. Wait
until the updating is complete.
■
SIRIUS UPDATING
Displayed while the SiriusConnect receiver's firmware
is being updated.
■
INVALID CHANNEL
Displayed if you select an unavailable channel.
■
CALL SIRIUS
Displayed when you select a channel to which you are
not subscribed. Call SIRIUS if you want to subscribe.
■
CHECK SIRIUS TUNER
Displayed if the SiriusConnect receiver is not con-
nected. Make sure the SiriusConnect receiver is con-
nected properly, and make sure its AC adapter is
plugged in.
Terrestrial
112233445566
En
37