Installing The Boss S2 Module - Dell EMC PowerEdge R550 Installation And Service Manual

Figure 78. Removing the BOSS cover
Next steps
1. Replace the BOSS S2

Installing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, remove the air
Steps
1. Slide the BOSS cover on the BOSS S2 module. Using the Phillips #1 screwdriver, secure the BOSS cover on the BOSS S2
module with the M3 x 0.5 x 4.5 mm screw.
module.
Safety
Before working inside your
shroud.
instructions.
system.
Installing and removing system components 83