Installing The Boss S2 Module Blank - Dell PowerEdge T350 57C92 Installation And Service Manual

Figure 59. Removing the BOSS S2 module blank
Next steps
1. Replace the BOSS S2 module blank

Installing the BOSS S2 module blank

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the front bezel.
Steps
1. Align and slide the BOSS S2 module blank into the system bay.
2. Hold the BOSS S2 module blank into its place and tighten the captive screw.
72 Installing and removing system components
or install BOSS S2 card
Safety instructions.
Before working inside your
module.
system.