Battery Installation Guide; Power Up The Camera - CONCORD Eye-Q Fun.Cam User Manual

BATTERY INSTALLATION GUIDE

Power up the camera

Insert three AA-size batteries into the battery compartment. Please make
sure they are inserted into the camera following the polarity marked in the
battery compartment and that they are inserted in the sequence shown in
the diagram. We recommend alkaline batteries for better performance.
Press and hold the power button for around one second
and the camera should turn on with a double-beep
sound. The LCD panel will display the default screen.
Press and hold the power button again to turn off the
camera.
The power-up default settings are single capture, VGA
(640x480) image resolution, high image quality and flash
off. The 3-digit counter on the LCD indicates the number
of pictures stored in the camera. Simply click the shutter
button to take a picture. The camera will emit a high
tone double-beep and the counter will increase when a
picture is taken successfully.
The camera will switch itself off if it is idle for more than 45
seconds in order to save power. The camera will emit a
double-beep sound before switching itself off.
Warning:
• Do not remove the batteries otherwise pictures in the
camera will be lost.
• Always turn the camera off before removing the
batteries.
• The camera will retain images for around one minute
after the batteries are removed. Failure to replace the
batteries within this time frame will result in the loss
of your images.
8
1
3
2