Adjusting The Roller Scrapers; Adjusting The Transport Rollers; Mounting The Verticutter Reel - Toro Reelmaster 3100-D Series Operator's Manual

6
Adjusting the Roller
Scrapers
No Parts Required
Procedure
1. Loosen the flange nuts that secure the roller
scrapers (Figure
1. Front roller scraper
2. Rear roller scraper
2. Move the scraper rods in or out to attain 0.0 to
0.75 mm (0.0 to 0.03 inch) clearance between
the scraper and roller.
3. Ensure that the scraper rod is parallel to the
roller and to the level surface.
4. Tighten the flange nuts to lock the adjustment.
7
Adjusting the Transport
Rollers
No Parts Required
Procedure
Before the verticutters are lowered to the shop floor
or removed from the traction unit, lower the transport
9).
Figure 9
3. Transport roller
4. Cotter pin
rollers (Figure 9) to protect the blades from hard
surface contact.
1. Remove the cotter pin that secures the transport
roller bracket to the side plate pin.
2. Position the transport roller as follows:
•
Lower the roller bracket before the verticutter
is lowered to the shop floor.
•
Raise the roller bracket after the verticutter is
raised to the operating position.
3. Secure the transport roller bracket to the side
plate pin with the cotter pin.
4. Repeat the procedure on the opposite end of
the verticutter.
8
Mounting the Verticutter
Reel
No Parts Required
Procedure
g012271
Important:
When lowering the verticutter reels,
take care to prevent damage to the reel blades due
to contact with a concrete floor or a paved surface.
Lower the transport rollers before lowering the
verticuttiers to a concrete floor or a paved surface.
Figure 10 shows the orientation of the hydraulic drive
motor for each of the locations.
Verticutter reels are mounted to traction unit the
same way cutting units are. Refer to the traction unit
Operator's Manual for mounting instructions.
1. Verticutter 1
2. Verticutter 2
3. Verticutter 3
8
Figure 10
4. Weight
5. Reel motor
g196714