Panasonic WJ-VPU4000 Operating Instructions Manual page 24

Control Reference Guide
Mounting bracket and ventilation
The recorder can be mounted by turning the mounting bracket 90 degrees in a
center console or trunk. The figure below is an example of mounting in a trunk.
(Factory default setting)
For center console mounting, remove the screw to remove the mounting bracket.
Rotate the mounting bracket 90° and attach the screw again.
Panasonic i-PRO Sensing Solutions Co., Ltd. assumes no responsibility for
injuries or property damage resulting from failures arising out of improper
installation or operation inconsistent with this documentation.
Example of installation in a trunk
Step1
Loosen 4 mounting bracket attaching
screws to remove the mounting
brackets.
Mounting bracket
(on the other side as well)
Mounting bracket
attaching screws
Step2
Drill 2 holes in each removed mounting
bracket, 4 holes in total.
Step3
Attach the drilled mounting brackets to
their original positions.
Recommended tightening torque:
1.5 N·m {1.11 lbf·ft}
24
(continued)
Step4
Fix the recorder to the trunk with fixing
screws (4 pcs.) (M4 × 16 mm
{5/8 inches}*, locally procured).
* The screw length is an example when
installing the recorder on a robust
trunk floor with a thickness of 20 mm
{25/32 inches} or more.
Minimum pull-out strength:
196 N {44 lbf} (per 1 pc.)
Trunk oor
Note:
• Consult your supplier and request
help with installation.