Emerson Magtech LTM−350 Series Instruction And Operation Manual page 23

August 2020
For Direct insertion transmitters:
1. Move the float up and down along the length of the
sensor probe. The float should move freely from the
bottom float stop to the top process connection.
2. Remove the float from sensor and visually inspect for
damage such as dents or visible holes.
3. The float can be checked for leaks by submerging it in
water and observing for air bubbles.
8.4 Identification
For an SIS application the LTM-350 must be specified at
the time of order due to rigorous in house testing. A SIL
rated LTM-350 can be identified with approval markings
on the label of instrument.
Section 9: Warranty
All Magtech products are warranted against defects in
materials and workmanship for eighteen months from the
date of shipment or twelve months from the date of
installation, whichever period expires first. The MLI
chamber and process connections are guaranteed for the
life of the tank or vessel to which it is attached. Floats are
guaranteed for two years. Magtech will repair or replace at
its discretion those products that fail to perform as
specified, with the following exceptions:
1. Products repaired or modified by persons that are not
authorized by Magtech.
2. Products subjected to misuse, negligence or accidents.
3. Products that are connected, installed, or otherwise used
in such a way not in strict accordance with manufacturer's
instructions.
This warranty is in lieu of any other warranty expressed or
implied by any party other than Magtech. Repairs and/or
replacements shall be at the sole discretion of Magtech
based on the terms and conditions of this warranty.
Defective products shall be returned to the factory prepaid
by the buyer after obtaining a Return Authorization
Number from Magtech.
replacements will be performed at the factory in Pearland.
Surface return freight will be paid by Magtech. Factory
warranties do not include field service.
warranty repairs will be at the buyer's expense.
Any modifications to terms and conditions of this warranty
will not be binding unless made in writing and signed by
an authorized agent or official of Magtech.
NOTE: ALL MAGTECH INSTRUMENTS SHOULD BE
UNPACKED AND
RECEIPT. MAGTECH INSTRUMENTS ARE SHIPPED FOB
FACTORY AND ARE FULLY PROTECTED AGAINST DAMAGE
OR LOSS DURING SHIPMENT. ANY CLAIMS FOR PARTS
DAMAGED DURING SHIPMENT SHOULD BE SUBMITTED
WITHIN 15 DAYS OF RECEIPT OF GOODS BY CUSTOMER.
Emerson Automation Solutions- Magtech
3902 Magnolia Road, Pearland, Texas, 77584-1610, USA
23
Reference Manual
L231040 Rev AD
9.0 Warranty
All warranty
Field service
THOROUGHLY INSPECTED
repairs or
UPON