Method Of Attaching Universal Joint - Baroness TDA1200 Owner's Operating Manual

Tractor mounted aerator

Hide thumbs Also See for TDA1200:

Table of Contents

8.Attach the right lower link and lock the link pin.

9.Align the implement mounting hole in the top link (upper link) with the mounting holes of

the machine.

If the top link (upper link) is not aligned with the mounting pin hole, loosen the lock nuts

on the top link and adjust its length.

10.Attach the top link (upper link) , lock the link pin and tighten the lock nuts.

11.Start the tractor's engine and raise the machine slightly with the lift lever.

When vibration is generated in the machine, the vibration will cause damages to the lawn,

tractor and the machine.

12.Adjust the top link (upper link) so that the machine can level off.

* Adjust it so that the machine vibrates only 10 - 20 mm on the right and left sides evenly.

Check the vibration on the right and left sides of the machine. If the vibration is large,

adjust so that the play is reduced.

6-3. Method of Attaching Universal Joint

Before attaching the universal joint, disengage the PTO clutch and stop the tractor's

engine.

Do not mount the universal joint that is too long or too short.

A long universal joint prongs the tractor's PTO shaft or the attached machine's input shaft.

A short universal joint is in poor meshing engagement and will cause breakage.

The universal joint length depends on the type of tractor to be linked.

Do not raise the machine with only one side of tractor's lower links attached.

Do not continue rotating the universal joint with the machine raised.

The universal joint or the machine may break.

1.Set the tractor PTO speed change lever to the "Neutral" position.

2.Raise or lower the machine slowly to adjust its height so that the height of tractor's PTO

shaft and that of machine's input shaft are on the same level.

3.Close the hydraulic stop valve completely.

Note:

For the location of the hydraulic stop valve, refer to the tractor operator's manual.

4.Apply the tractor parking brake and stop the engine.

5.Hang the chain of universal joint on the top link (lift link).

Table of Contents

Tda1600