Honda TRX250TE 2019 Owner's Manual page 130

Gear Case Oil
1. Park the ATV on level ground.
2. Place an oil drain pan under the oil drain bolt (1).
3. Remove the oil fill cap (2), drain bolt and sealing washer (3).
4. After the oil has completely drained, reinstall the drain bolt with
a new sealing washer, and tighten it to the specified torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
5. Fill the gear case with the recommended oil.
80 cm 3 (2.7 US oz , 2.8 Imp oz)
6. Remove the oil level check bolt (4) and sealing washer. Make sure
the oil level reaches the oil level check hole (5).
7. Install the oil fill cap and tighten it to the specified torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
8. Install the oil level check bolt with a new sealing washer and
tighten it to the specified torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
REAR
(5)
(4)
(1) oil drain bolt
(2) oil fill cap
(3) sealing washer
120 Servicing Your Honda
(2)
(3)
(4) oil level check bolt
(5) oil level check hole
(3)
(1)