Connecting The Digital Outputs - Siemens SITRANS DA400 Operating Instructions Manual

Connecting

5.5 Connecting the digital outputs

5.5 Connecting the digital outputs
Safety notes
NOTICE
Protection against explosion
Use only approved safe connector hardeners in conformity with DIN 19234, as described in
the chapter "Technical data."
Procedure
In order to enable the digital outputs, proceed as follows:
1. For up to six digital outputs, it is recommended that you use a 12-wire cable, which is fed
through a cable gland ➀.
2. Connect the signal conduit according to the following table.
Digital signal
See also
Terminal assignment (Page 25)
Cable gland (Page 26)
Device technical data (Page 77)
Connect the ground (Page 33)
28
DO 1
+ 31
- 32
DO 2 DO 3
41 51
42 52
SITRANS DA400 for material flow monitoring with protection against explosion
DO 4 DO 5
61 71
62 72
Operating Instructions, 09/2007, A5E00841152-01
DO 6
81
82