Siemens SIREMOBIL Iso-C Service Instructions Manual page 6

6
Fig. 10
•
Remove the screws for the end stop (1/Fig.10).
•
Connect the cables to both microswitches (refer to S3,S4/Fig.3 and Fig.11).
•
Reconnect X23.
•
Place the cover with the brake switches on the C-arm and plug in the test board.
•
Switch ON the SIREMOBIL.
•
Release the horizontal lift brake (press the switch, the LED lights).
•
Move the vertical lifting column up and down until you are able to hammer the end stop
(1/Fig.10) out of the horizontal carriage in the direction of the arrows (arrows/Fig. 10)
without applying pressure to the shaft.
•
Once the end stop has been removed, the shaft should lie horizontal within the
horizontal carriage and should not be pressing against it.
•
Switch OFF the SIREMOBIL.
SIREMOBIL Iso-C
Replacing the horizontal lift brake
1
Fig. 11
SPR2-230.076.01
Rev. 01 02/99
S3.Comm
S3.NL
S3.2
Page 6 of 16
TD SD 24
S4.Comm
S4.NL
S4.2
Siemens AG
Medical Engineering