Advertisement
PRECAUTIONS
1
Only trained and qualified
personnel are recommended to
install and set up the sensor.
1
INSTALLATION
• Run conduit prior to installing sensor.
• Fully adjust sensor after entire installation is complete.
Swing Doors
2
WIRING
Connect the existing 2 wires running through the wall (previously used for the activation relay of the
hardwired, mechanical push plate) to the MS09 sensor's PWR (black) and PWR (red) terminals.
At the door control, move the 2 wires from the activation circuit to power (see Technical Specifications for
power information).
POWER – red (12 – 24 VAC/VDC)
POWER – black (12 – 24 VAC/VDC)
Page 2 of 4
Always test the proper
operation of the installation
before leaving the premises.
Sliding Doors
NO – green
NC – yellow
COM (at door control) – white
Industrial Doors
NOTE: Do not install the sensor within the swing path of the door.
The warranty is invalid if
unauthorized repairs are made
or attempted by unauthorized
personnel.
Cleanrooms
75.5746.05 MS09 20210115
Advertisement
