Toro Reelmaster 3555 Operator's Manual page 22

Mow/Transport Slide
Using your heel, move the mow/transport slide
26) left to the T
RANSPORT
position.
•
The cutting units only operate when the
mow/transport slide is in the M
•
The cutting units do not lower when the
mow/transport slide is in the T
Tilt-Steering Lever
Pull the tilt-steering lever
steering wheel to the desired position. Then push the
lever forward to secure the position.
Control Console
Figure 27
1. Parking brake
2. Ignition switch
3. Cutting unit drive switch
4. Diagnostic light
5. Lower mow/raise control
lever
6. Hour meter
Ignition Switch
Use the ignition switch
and lights. The ignition switch has 3 positions:
•
The S O position shuts off the engine.
HUT FF
•
The R /P
UN REHEAT
run or preheats the cylinder head of the engine.
•
The S position energizes the starter.
TART
Note:
When the key is in the R
the glow plug energizes and the indicator light
illuminates for approximately 7 seconds.
position or right to the M
position.
OW
position.
RANSPORT
(Figure 26) back to tilt the
7. Oil-pressure light
8. Temperature light
9. Light switch
10. Glow-plug indicator light
11. Throttle
12. Alternator light
(Figure 27) to run the engine
position allows the engine to
/P position,
UN REHEAT
Throttle
Move the throttle
(Figure
engine speed and rearward to decrease the engine
OW
speed.
Cutting Unit Drive Switch
The cutting unit drive switch
positions: E
operates a solenoid valve on the valve bank to drive
the cutting units.
Hour Meter
The hour meter
of machine operation. It starts to function whenever
the key switch is on.
Lower Mow/Raise Lever
Use the lower mow/raise lever
the cutting units and run reels or raises the cutting
units and stop the reels.
You cannot lower the cutting units when the
mow/transport lever is in the T
Note:
When the cutting unit drive switch is in the
E position, you do not need to hold the lever in
NGAGE
the forward position while the cutting units are lowered
or raised.
Engine Coolant Temperature
g019980
Warning Light
The temperature warning light
if the engine coolant temperature is high. At this
temperature, the cutting units shut off. If the coolant
temperature rises another 5.5°C (10°F), the engine
shuts off to prevent further damage.
Oil-Pressure Warning Light
The oil-pressure warning light
engine oil pressure drops below a safe level.
Alternator Light
The alternator light
engine runs. If the alternator light illuminates while the
engine runs, check the charging system and repair
it as necessary.
Glow-Plug Indicator
The glow-plug indicator light
when the glow plugs are energized.
22
(Figure 27) forward to increase the
(Figure
and D
NGAGE ISENGAGE
(Figure 27) indicates the total hours
(Figure
RANSPORT
(Figure
(Figure
(Figure 27) shuts off when the
(Figure
27) has 2
. The rocker switch
27) to lower
position.
27) illuminates
27) glows if the
27) illuminates