Toro Reelmaster 3555 Operator's Manual page 16

1. Lift arm
2. Carrier frame shaft
Aligning the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Remove the lynch pin and washer securing the
lift-arm pivot shaft to the lift arm and slide the
lift-arm pivot shaft out of the lift arm
1. Lift-arm shaft lynch pin and washer
2. Insert the lift-arm yoke onto the carrier frame
shaft (Figure 10).
3. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
11).
Assembling the Cutting Units to
the Lift Arms
1. Insert the cap over the carrier frame shaft and
lift-arm yoke.
2. Secure the cap and the carrier frame shaft to the
lift-arm yoke with the snapper pin.
Figure 10
3. Lift-arm pivot yoke
(Figure
Figure 11
Note:
desired or use the hole if the cutting unit is to be
locked in position
3. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
in the cutting unit Operator's Manual.
g020321
1. Lift-arm chain
2. Chain bracket
Installing the Reel Motors
1. Coat the spline shaft of the reel motor with clean
grease.
2. Lubricate the reel-motor O-ring with oil, and
11).
install it onto the motor flange.
3. Install the motor by rotating it clockwise so that
the motor flanges clear the locknuts
Important:
are not twisted, kinked, or at risk of being
pinched.
g003979
(Figure
1. Reel-drive motor
16
Use the slot if a steering cutting unit is
(Figure 9).
(Figure 12).
Use the number of chain links specified
Figure 12
3. Snapper pin
Ensure that the reel motor hoses
Figure 13
2. Mounting nuts
g003948
(Figure 13).
g020322