Toro Reelmaster 3555 Operator's Manual page 15

Installing the Hose Guide
Models 03820 and 03821
On cutting unit 4 (left front) and cutting unit 5 (right
front), use the rod-bracket mounting nuts to install the
hose guides to the front of the cutting-unit tabs. The
hose guides should lean toward the center cutting unit
(Figure 6, Figure 7, and
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Hose guide (left side
shown)
2. Rod bracket
Figure 8).
Figure 6
5. Cutting unit 5
6. Reel motor
7. Weight
Figure 7
3. Nuts
1. Hose guides (each must lean toward the center cutting unit)
Aligning the Cutting Units to the
Lift Arms
All Front Cutting Units, and Any Rear Cutting
Units with a 1.2 cm (3/4 inch) or Lower Height
of Cut
g031275
1. Lower all the lift arms completely.
2. Remove the snapper pin and the cap from the
lift-arm pivot yoke
1. Snapper pin
3. For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier frame
shaft up into the lift-arm pivot yoke
g015160
15
Figure 8
(Figure 9).
Figure 9
2. Cap
(Figure
g289454
g003975
10).